Homemade "3 Types" of Rooting Hormone Water
High-quality rooting hormone water can significantly improve the survival rate during the cutting process of green plants. This article will uncover the secrets of making plant rooting hormone water from three common kitchen materials, which are not only economical and environmentally friendly but also can activate plant cell division and promote healthy root growth in branches.
One, White Sugar Water Rooting Method
1.1 Scientific Principle Analysis
White sugar extracted from sugarcane contains various organic acids and trace elements, among which glucose can provide energy for plant cell division, and sucrase can stimulate the formation of callus tissue. Experimental data show that 0.5% concentration sugar water can shorten the rooting period of roses by 3-5 days.
1.2 Golden Proportion Scheme
Dissolve 5 grams of white sugar in 1 liter of cool boiled water and stir until completely dissolved. It is recommended to use warm water at 30℃ to accelerate dissolution, but be careful not to make the concentration too high to cause the epidermis of branches to shrink. Soaking time should be controlled between 40-60 minutes, and it is necessary to rinse with clean water after soaking to remove any remaining sugar.
Two, Willow Branch Salicylic Acid Preparation
2.1 Natural Root Promoting Ingredients
New willow branches are rich in salicylic acid, reaching 0.2-0.5%, which can enhance the plant's resistance to stress and promote the differentiation of root primordia. According to horticultural research, the effect of willow water on root growth can reach 78% of commercial rooting agents.
2.2 Fermentation Key Steps
Choose young branches with a diameter of 1cm and cut them into 10cm sections, then tap the skin with a hammer and put them into a glass bottle. Add clean water at a ratio of 1:3 and maintain a 25℃ environment for fermentation for 15 days, opening the lid to release gas every week. Before use, filter and dilute at a ratio of 1:10.
Three, Aspirin Rooting Solution
3.1 Medicinal Ingredient Transformation
Each 0.3g aspirin tablet contains 250mg of acetylsalicylic acid, which hydrolyzes to produce salicylic acid that plants can absorb. The German Plant Research Institute has confirmed that its effect on promoting cell division is 20% higher than that of willow water.
3.2 Accurate Dosage Control
Crush 3 tablets into powder and dissolve in 500ml of warm water, let it stand for 24 hours to complete hydrolysis. It is recommended to use with Vitamin B12 (add 1 tablet per liter) to enhance anti-corrosion ability. For hydroponic plants, 5-8 drops can be added every week.
The three homemade rooting hormones each have their own characteristics: white sugar water is suitable for succulents and other fleshy stems, willow water is significant for woody plants, and the aspirin solution is suitable for valuable flowers. It is recommended to alternate their use according to the characteristics of the plants, combined with breathable substrates such as perlite, to achieve a cutting success rate of over 90%. Regularly observe the condition of the branches and adjust the soaking time in a timely manner to allow each plant to burst into vibrant vitality.