When is it suitable to propagate Milan flowers by cutting in months?
This article provides a detailed introduction to the most suitable months for propagating Milan flowers through cutting and describes the fastest method for rooting Milan flower cuttings. Let's learn about it together.
If using old branches for cutting, select April-May; for new branches, select June-August. The cutting method is as follows:
Cut the cuttings: The cuttings must be healthy, each segment 12-15 centimeters long, and dipped in rooting powder at the bottom.
Prepare the substrate: Prepare a substrate that is loose, breathable, and has good drainage.
Plant the cuttings: First, make a small hole in the surface of the substrate with a stick, insert the cutting, press the soil, and water thoroughly.
Post-cut care: Provide a warm, well-ventilated environment and apply thin fertilizer frequently after the cuttings start to sprout.
I. Cutting Time
Milan flowers thrive in spring and summer, so it's best to cut during these seasons as well. For old branches, it's best to cut in April-May of spring; for the current year's new branches, it's best to cut between June-August. The climate during these periods is suitable, ensuring good growth and easy management after cutting.
II. Cutting Method
Cut the cuttings: The cuttings must be healthy and free from diseases and pests to ensure a high survival rate. Each cutting should be 12-15 centimeters long. After cutting, remove the leaves from the bottom part of the cutting to reduce nutrient and water consumption, promoting faster rooting and increasing survival rate. The bottom cut should be made diagonally to better absorb water and nutrients. It's best to apply rooting powder to the cut, which can accelerate rooting.
Prepare the substrate: The substrate should be loose, breathable, have good drainage, and slightly acidic, as Milan flowers prefer such an environment. The soil should be suitable to improve the survival rate. A mixture of peat soil and river sand can be used, or a special flower soil can be purchased. Note that the soil must be sterilized before use, either by sunbathing in direct sunlight or using a special disinfectant solution to prevent eggs or germs from affecting later growth.
Plant the cuttings: After the cuttings and substrate are prepared, you can proceed with the cutting. First, make a small hole in the surface of the substrate with a stick, insert the cutting, press the soil around it, and water thoroughly, then cover with plastic film to keep the temperature and humidity, which promotes rooting and survival in a suitable environment.
Post-cut care: Milan flowers prefer a warm, humid environment. Make sure to water promptly when the soil is dry, watering thoroughly each time but avoiding waterlogging. It's best to apply thin fertilizer frequently when new branches start to sprout to ensure adequate nutrition, which promotes better sprouting and faster growth.
The above content is about the most suitable months for propagating Milan flowers through cutting and describes the fastest method for rooting Milan flower cuttings, for the reference of green plant enthusiasts, hoping to solve your problems in green plant and flower management.