How to propagate Milan flowers easily
For most women, the knowledge about how to propagate Milan flowers easily, as well as the timing and methods for Milan cutting and green plant flowers, will be introduced by the editor below.
If using old branches for cutting, choose April to May; for new branches, choose June to August. The cutting method is as follows:
Take cuttings: The cuttings must be healthy, each piece 12-15 cm long, dipped in rooting powder at the bottom.
Prepare the substrate: Prepare a loose, breathable, and well-draining substrate.
Insert into soil: First, make a small hole in the surface of the substrate with a stick, insert the cutting, compact the soil, and water thoroughly.
Post-cut care: Provide a warm and well-ventilated environment, and apply a thin fertilizer frequently after germination starts.
I. Cutting Time
The growing season of Milan flowers is in spring and summer, so it's best to propagate at the same time. If using old branches, it's best to propagate in April to May. If using new branches of the current year, it's best to propagate between June and August. The climate during these time periods is suitable, ensuring good growth and easy management after propagation.
II. Cutting Method
Take cuttings: The cuttings must be healthy and free from diseases and pests to ensure a high survival rate. Each cutting should be 12-15 cm long, not too long. After cutting, remove the leaves from the lower part of the cutting to reduce nutrient and water consumption, which can promote faster rooting and increase survival rate. The bottom cut should be diagonal to better absorb water and nutrients. It's best to apply rooting powder to the cut to accelerate rooting.
Prepare the substrate: The substrate should be loose, breathable, well-draining, and slightly acidic, as Milan flowers prefer this type of environment. Suitable soil can improve survival rate. When preparing the soil, mix peat soil and river sand, or use special soil for flowers. Note that the soil you prepare must be disinfected before use. It can be exposed to direct sunlight or disinfected with a special solution to prevent eggs or pathogens from affecting later growth.
Insert into soil: After the cuttings and substrate are prepared, proceed with the cutting. Make a small hole in the substrate surface with a stick, insert the cutting, compact the surrounding soil, and water thoroughly, then cover with plastic film to maintain temperature and humidity. In a suitable environment, it will root and survive quickly.
Post-cut care: Milan flowers prefer a warm and humid environment. Water promptly when the soil is dry, making sure to water thoroughly but without积水. When new branches and leaves start to grow, apply a thin fertilizer frequently to ensure sufficient nutrients, which will promote better growth and faster development.
The above is all about how to propagate Milan flowers easily and the timing and methods for Milan cutting. Green plant enthusiasts might find it useful to refer to this.