Rose Stem Grafting on Cherry Blossom Lollipops
Do you know about these? The knowledge about grafting cherry blossom lollipops onto rose stems, please refer to the detailed introduction below.
Many flower enthusiasts love cherry blossom lollipops, and early spring is a great time for grafting them. However, there is an issue: usually, we use thornless rose stems, without roots, to graft cherry blossom lollipops, and direct grafting is often difficult to survive. How can we improve the survival rate of the grafting? Today, I'll teach you two small methods.
Grafting Cherry Blossom Lollipops onto Rose Stems to Improve Survival Rate
Grafting cherry blossom lollipops is relatively simple, and both cleft grafting and bud grafting can be used. For specific grafting methods, you can refer to the book "How to Grow Cherry Blossoms from Scratch." Today, let's focus on how to improve the survival rate after grafting.
The rose stems we buy are usually without roots. Directly grafting with rootless rose stems and then cutting often results in a low survival rate of the graft, because the rose stems are relatively long and consume a lot of energy, making it easy for moisture to fall behind, leading to dehydration of the grafted buds and ultimately graft failure.
To improve the survival rate of cuttings after grafting, I give you two small suggestions.
1. -- Soaking in Water to Root --
Soaking in water to root is simple. After grafting, directly place the bottom of the rose stem in water to soak, using a hydroponic method to let the rose stem root. Since it is soaked in water, the rose stem absorbs sufficient moisture, and the scion does not easily wither from dehydration.
Some say to change to soil cultivation after callus formation from soaking in water, but this transition to soil cultivation also carries risks. I suggest soaking until roots emerge before transplanting.
2. -- Water-Sitting to Root --
Soaking in water to root is a water cutting method, and after the roots grow, it is a bare-root transplant, which is not very good for the seedlings. We can also use a second method, the water-sitting method.
First, fill a flower pot with planting soil, then insert the grafted rose stem into it. After watering thoroughly, place a water-filled saucer under the pot and put the planted rose stem pot into the water-filled saucer.
This way, the potting soil can continuously absorb moisture from the saucer, maintaining sufficient humidity, and the rose branches will not easily lack water, nor will the grafted scion lose water, greatly improving the survival rate of cuttings after grafting.
As long as the grafted scion has not shown obvious signs of growth, it means the rose stem has not rooted yet, and the saucer should always have water. When the grafted bud has sprouted and unfolded its leaves, it indicates the rose stem has rooted. At this point, you can remove the saucer and maintain watering when dry and fertilize appropriately.
The key to improving the survival rate of rose stems grafted and then cut is the management of moisture (G-Y), which must be kept sufficient and not lacking.
In addition, avoiding rain after grafting is also an important factor in improving the survival rate of the graft. If the grafting site is not protected from rain, it can easily become infected, leading to graft failure or blackening of the rose stem.
Now is a great time for grafting. If you also like cherry blossom lollipops, why not try grafting them yourself? It's very rewarding!
The above is a detailed explanation of grafting cherry blossom lollipops onto rose stems and methods to improve the survival rate. I hope this article can provide you with help in green plant management!