The complete process of potting newly purchased living stone flowers
Main content core guide: Knowledge about succulent plants - living stone flowers, the complete process of potting newly purchased living stone flowers, let's learn about it together.
In March, the newly purchased living stone flowers have not yet completed their peeling process. When you receive them, you'll find many fibrous roots that need to be trimmed and the small dead roots removed. Let the wounds dry in a well-ventilated, shaded area before potting.
After the roots are trimmed, it's time to prepare the granular soil for the bottom of the pot. I chose ceramsite, but any large-grained material will do. Then, prepare the soil needed for the growth of the living stone flowers in the middle layer. My soil mixture is coal slag + peat + perlite + vermiculite + furadan for preventing diseases and pests. The soil should be breathable without a specific ratio, and individuals can mix the soil according to their preferences. Then pour the soil with ceramsite into the plate, filling it three-quarters full. I use a small pot measuring 7*7*8 cm, with a side that is 10 millimeters high. Generally, I level the side, but enthusiasts can measure the amount of soil based on the size of the living stone flowers. The soil is usually dry, which means dry planting (easier to handle than wet planting).
Then use a round-tipped tweezers to hold the root of the living stone flower, insert the tweezers with the flower into the pot, and release the tweezers so that the flower stands upright.
Finally, pour the prepared granules around the base of the living stone flower, making it level with the flower. After growth, the living stone flower will be higher than the planting material we laid. I used lightweight stone and washed sand. Do not water before the peeling is complete. Let it bask in the sun until the peeling is fully completed, then gradually return to normal watering. The watering schedule depends on the season you purchase the living stone flowers.
It's important to note that the sun can be very harsh in March, easily burning the epidermis. Please pay attention to the strength of the sun. The general practice is to gradually expose the living stone flowers to the sun to allow them to adapt to the environment. If the living stone flowers have already completed peeling, enthusiasts can water them after potting, with the principle of less water at first, gradually increasing it.
Living stone flowers that have just been watered after peeling should not be exposed to direct sunlight. They should be cared for in a well-ventilated, shaded area for about three days, then gradually exposed to the sun. Below is a picture of the effect of laying the planting material. The method is the same for planting one or multiple flowers: plant the living stone flowers first and then lay the planting material on top. The process for planting other plants like meat hooks can refer to this operation. The methods are basically the same.
The above is a comprehensive method explanation of the complete process of potting newly purchased living stone flowers (with pictures), hoping it can act as a catalyst to solve your problems with green plants.