How to propagate the succulent plant "Sorceress" and the cutting propagation method for "Sorceress" succulents.

How to propagate the succulent plant "Black Wizard"? Here are some small experiences on the care of green plants for the propagation methods of the succulent plant "Black Wizard" and the propagation method of cutting, which are very useful tips, recommended for collection!Black Wizard is dropping leaves, stems are turning black, and branches are becoming soft! It is suggested to "cut the head" immediately.Recently, a neighbor asked me that his newly purchased Black Wizard seems to be unwell recently, leaves are drooping and not vigorous, and the leaves on the small head below are almost all about to fall off, and it has only been less than a month since it arrived at home. The neighbor said he bought it from a flourishing store and bought it because it was cheap. I went to his house to check it out, and as soon as I saw it, I felt that it was almost over, a typical cutting old stake.What is a cutting old stake? Why does it become this way after only a short period of more than twenty days at home? Let me briefly explain to everyone what a cutting old stake is. It is a branch cut from the original Black Wizard that is then planted into the soil. This can also grow into an old stake without too much time, which is a typical case of selling flowers by vendors. I pinched the main stem of the Black Wizard and found that it was very soft and rotten inside with just two fingers.What should we do in such cases? I have a suggestion for everyone: if your Black Wizard has this situation, you must take the following steps to save the plant's life to the maximum extent. Let's see how I did it.First, cut the head. Take the Black Wizard to the yard, prepare a sharp scalpel, and prepare carbendazim and new potting soil, which must be disinfected.How to propagate the succulent plant "Black Wizard"?Cut the head of the Black Wizard directly with a scalpel, trim it carefully with a scalpel, remove all the blackened branches, and continue until you see the green main stem. Then let it dry naturally in a shaded and well-ventilated place, allowing the cut part to air-dry for about two to three days. After drying, we use the cut head for propagation by cutting.The soil matrix for cutting can be sand or nutrient-rich soil. I prefer sand because it roots faster, and sand is more breathable and loose. Spread the soil in the pot flat and place the Black Wizard flat on the soil.Additionally, during the natural drying process, you can apply a little rooting hormone every other day to ensure good rooting when cutting. The placement should not be exposed to sunlight. After a week, if you see fine roots, you can then pot it for care. For the succulent Black Wizard with rotting leaves and falling leaves, this method is the only way to ensure its survival.In daily life, how to correctly care for the Black Wizard we buy at home is actually very simple, just pay attention to watering and avoid waterlogging. Place it in a sunny location and allow it to receive normal sunlight.The above content introduces the propagation methods of the succulent plant "Black Wizard" and the detailed propagation method of cutting the succulent Black Wizard, hoping it can be helpful to you!