How to propagate Hoya quickly
A small piece of knowledge to share with you on how to propagate Hoya quickly and teach you the skills of fast propagation in the aspect of green plant maintenance, the specific introduction is as follows:
Hoya is a very rich variety of vines, originally growing in rainforest areas, preferring higher humidity and moderate scattered light, and does not require much water. If you want to plant some vines on the balcony, Hoya is also a good choice.
There are several different methods to propagate Hoya, including leaf cutting propagation, stem cutting propagation, and layering propagation.
1. Leaf cutting propagation
You can choose strong leaves that are especially thick and robust at the bottom of the branches, and definitely do not choose yellow leaves or leaves with fungal diseases. Also, avoid leaves that are too old at the bottom of the branches.
Hoya belongs to a type of succulent plant, so leaf cutting propagation can be chosen. Prepare some small seedling trays in advance with large and multiple drainage holes at the bottom. The soil is generally a mixture of peat soil and perlite, in a ratio of 1:1, or you can also choose to use vermiculite for cultivation.
Perlite and vermiculite are both good materials for cutting propagation, as they have good breathability and water retention.
The leaves of Hoya can be inserted diagonally into the soil, with only about 2 to 3 centimeters of the petiole inserted into the soil.
How to propagate Hoya quickly
The above image shows the leaf cutting propagation of new Hoya leaves
After cutting the leaves of Hoya, do not insert them immediately. You can first place them in a well-ventilated and shaded place for 2 to 3 days before inserting them into the soil. This is to avoid wound infection, allowing the wound to heal. If you want to increase the chance of rooting and germination, you can dip the bottom of the petiole in some rooting powder.
During leaf cutting propagation, it is important to keep the soil slightly moist without over-frequent watering. Also, maintain a certain humidity in the air to avoid dryness, with a temperature between 20 to 25 degrees.
2. Stem cutting propagation
Hoya is generally propagated by stem cuttings. Although leaf cutting can root and germinate, the growth rate is too slow.
You can cut several segments of branches about 7 to 9 centimeters long, each with about 2 to 3 growth nodes, at least one node, otherwise it will not root and germinate normally.
Just like before cutting propagation, you can dip the bottom of the branches in a little rooting powder, and also pay attention to preparing suitable soil, which is not much different from leaf cutting propagation.