White Bear succulent propagation soil
The editor answers the planting content of flower propagation for everyone, the soil used for the propagation of White Bear succulents, and corrections are welcome if there are any mistakes!
The most common method for propagating White Bear succulents is cutting, which is the same as the method for Bear's Child. This article mainly introduces the soil used for cutting propagation of White Bear, and also touches upon some maintenance tips. It still has very good reference value for flower enthusiasts who are propagating White Bear for the first time.
Soil: After March, start using a mix of 50% coconut fiber and 50% granules. The granules are made of炉灰渣 (1-6mm炉灰渣), which is随处可见 in the Northeast. I used to use volcanic rock and add a little diatomite. Coconut fiber is used because practice has shown that its coarse fibers are particularly beneficial for White Bear to develop roots. The cutting soil must have good moisture retention and be loose, so that the cuttings do not rot. As for mature White Bear plants, the proportion of granules can be increased to 60%.
Fertilization: This is even simpler. I usually lay a layer of large granules at the bottom, then a layer of soil, and then a layer of chicken manure granules. I use a lot of them, so basically no additional fertilization is needed.
Light and watering: I always keep them in full sun and plenty of water, which needs to be adjusted according to the actual coordinates. Bears like water.
I usually see roots in about 20 days after cutting. If there are no炉渣, other granules can be used.
The above is [] all about the soil used for the propagation of White Bear succulents. Have green plant enthusiasts understood it?