Method of Cultivating the fleshy plant Red Finger
This article introduces the content about the fleshy plant Red Finger, including its cultivation methods. Next, the editor will provide an introduction.
Red Finger Pachysedum 'Ganzhou' is a succulent plant from the Crassulaceae family, belonging to the thick-leafed genus. It is a cross-bred variety between the thick-leafed and Sedum genera.
Watering for Red Finger should be thorough only when the soil is completely dry, and no watering when it's not dry. There is no obvious dormancy period, and it can be exposed to full sunlight. In summer, ensure ventilation and shading, water 3 to 4 times a month, and provide a small amount of water near the pot edge to slowly endure the hot summer, maintaining the plant's roots from drying out due to excessive dryness.
In winter, reduce watering gradually when the temperature is below 3 degrees Celsius, and keep the potting soil dry below 0 degrees Celsius, trying to maintain a temperature not lower than minus 3 degrees. This will allow the plant to safely survive the winter. Water less in winter, and increase watering gradually in spring to avoid root rot.
There is a significant difference between the north and south, and the cultivation methods for homes and greenhouses vary. Red Finger is a relatively easy-to-grow variety with no obvious diseases or pests. Generally, just sprinkle some Furadan on the soil surface at the beginning of summer and winter. Red Finger easily sheds leaves, which happens when there is too much water or too much water during seasonal changes. Leaves can easily fall off with a slight touch. Reducing watering or gradually increasing it can help avoid leaf shedding. The shed leaves, if plump, can be used for leaf propagation, which is very easy. Usually, leaves are just left on the soil surface and they will naturally sprout roots and small leaves, becoming independent seedlings.
After cutting the top, Red Finger easily grows lateral branches. If not cut, the old stem will grow very long before branching out to make it look more beautiful. When it's about to grow, it should be cut to stimulate side buds, making the plant look more beautiful when it grows in clusters.
The main propagation methods of Red Finger include sowing, dividing, cutting the top, and leaf propagation. Leaf propagation is commonly used, with the soil being a mixture of peat, perlite, and coal cinder, approximately in a 1:1:1 ratio. To isolate the plant from direct contact with the soil surface and for better aeration, a layer of clean river sand or pumice stones, about 3 to 5 millimeters in size, is often placed on top by the author.
This article shares a comprehensive explanation of the cultivation methods for the fleshy plant Red Finger, hoping to act as a stepping stone to solve your green plant problems.