How to propagate bamboo node begonia through cutting
Today, the editor will elaborate on how to propagate bamboo node begonia through cutting and share the introduction of fast rooting methods for green plants and flowers. If there are any mistakes, please feel free to correct them!
Bamboo node begonia is a succulent plant that is usually propagated by cutting, with a very high survival rate. It can be said to be an ideal plant for practicing cutting. As long as it is provided with a suitable environmental temperature, there is no problem with its survival. When the environmental temperature is around ten to twenty degrees, its survival condition is the best. Besides that, what kind of preliminary preparations need to be made?
Selection and treatment of branches
When propagating bamboo node begonia through cutting, it is best to choose older branches because young branches have poor rooting ability, and flowering branches should not be considered. After selecting a suitable branch on the mother plant, it needs to be treated.
First, remove some of the side branches and do not leave too many leaves at the bottom, two or three at the top are enough. This can reduce nutrient consumption and moisture evaporation, allowing the branch to grow roots faster.
Then comes the disinfection treatment. Prepare a basin of diluted disinfectant and soak the treated branch in the container for more than ten minutes. The disinfected branch cannot be planted directly in the soil. Although bacteria have been eliminated, the branch will rot if it absorbs water after planting, so it should be placed in a well-ventilated area to dry and allow the cut to heal. Finally, to promote faster root growth, you can sprinkle some rooting powder at the bottom or soak in rooting water.
Selection and treatment of potting soil
The requirement for the potting soil of bamboo node begonia is cleanliness, and all materials used must be disinfected to minimize bacterial attachment. Although achieving sterile conditions is difficult, at least the soil should have minimal bacteria. It prefers a loose matrix, so materials like river sand, vermiculite, perlite, and ceramsite are commonly used, as they are easy to handle.
How to propagate bamboo node begonia through cutting
There is no need to add excessive fertility to the matrix, which can even help its root growth. Fertilizers can be added after the branch has survived. If conditions permit, it is beneficial to perform a disinfection treatment each time the plant is transplanted or repotted.
Environmental maintenance
Under suitable temperature conditions, the survival of branches is quite apparent, but one should not be complacent and should still pay attention to environmental maintenance and water and fertilizer management.
The early growth of cuttings relies on the matrix and the nutrients stored in the branches. Therefore, you may notice that after the branches survive, they appear dehydrated. To avoid later issues, during the survival period, the environment should be kept in lower light to reduce moisture evaporation and increase humidity to ensure the branch's condition.
Before bamboo node begonia has survived, it is not recommended to fertilize. Any fertilizer applied cannot be absorbed by the branches and may even affect root growth. Therefore, only after the branches have fully rooted can fertilizer management be carried out. Water management is also similar, as branches without roots have poor water absorption. However, to avoid dryness and withering, a small amount of water can be supplemented, with the emphasis on maintaining environmental humidity.
The management during cutting is relatively simple. Remember not to be too strict with water and fertilizer, ensure the matrix is properly disinfected, and there are no other special requirements. What do you think?
The above is the content about how to propagate bamboo node begonia through cutting and share fast rooting methods from [Green Plant Enthusiast Website], hoping it is helpful to you!