How to propagate Huperzia serrata
A bit of knowledge to share with you on how to propagate Huperzia serrata and related content about the cutting techniques for this green plant. Let's share the detailed information next.
Huperzia serrata, also known as Euphorbia milii, is a plant from the Euphorbiaceae family. It has a very strong flowering ability, with flowers appearing at the tips of new branches on each twig, continuously growing and producing flower buds to bloom. Although the flowers are not large, the blooming period is very long, making it a favorite among many to keep a pot at home to enjoy the flowers. In fact, you don't necessarily need to buy it; you can simply cut a branch from someone else's plant and propagate it through cutting, whether it has leaves or not, both can survive.
We all know that if the branches of Huperzia serrata are not pruned during growth, they will grow taller and taller, and the leaves at the bottom will gradually fall off. If the branches are too long and not pruned, the top will have a single branch with not many side branches, making it very unattractive without flowers. We need to prune it in time, and don't throw away the pruned branches; they are very good for propagation. When selecting branches, avoid using tender ones and choose those with higher hardness, the long, leafless branches, cutting them short, leaving a 5 to 10 cm section, and make sure not to reverse the top and bottom.
After pruning, a white liquid will flow from the wound. We can add some rooting hormone to water, soak the branches in the water to clean the white liquid completely, and let them soak for about half an hour. Don't rush to propagate; then take them out and place them in a well-ventilated area. You can apply some mycostatic or plant ash to the wound. Let it dry for at least 2 to 3 days to allow the fresh wound to heal and dry.
When propagating, the soil mix must be remembered. Huperzia serrata is also a succulent plant, so the soil mix for propagation must ensure that granular soil accounts for about half. We can use river sand, volcanic rock, iridescent stone, or coal slag as the granular soil. The other half can be peat or decomposed leaf soil. Mix the soil well, moisten it, and then insert the branches into the soil about 2 centimeters deep. After planting, place it in a place with diffused light and good ventilation. When the surface of the potting soil dries down by about 1 to 2 centimeters, water it thoroughly. This way, the roots will slowly grow out within 1 to 2 weeks. Once the roots grow out, it will quickly grow side buds and leaves, which is very simple.
During propagation, make sure the potting soil is not too dry and ensure good ventilation. Do not use fertilizer. When you see that it starts to grow buds and grows quickly, you can transplant it into a new pot or directly add some fertilizer to promote rapid growth. This is the method of propagating Huperzia serrata through cutting.
The above information about how to propagate Huperzia serrata and the green plant cutting techniques may be helpful to you in your daily life!