How to propagate gardenia cuttings: Two methods summarized by an old farmer - Water insertion and soil insertion
This article introduces the small experience of propagating gardenia cuttings using two methods summarized by an old farmer - water insertion and soil insertion. Let's learn about it together.
Insertion is the preferred propagation method for most flower enthusiasts. It involves cutting the stems, leaves, roots, or buds of a plant and inserting them into soil, sand, or soaking in water until they root and can be planted. Gardenia, a commonly seen potted plant in homes, is mentioned here. It has a strong fragrance, lush branches and leaves, and very high ornamental value. So, how to propagate gardenia cuttings? There are two methods: water insertion and soil insertion, and they will be discussed below.
Gardenia cutting propagation methods
1. -- Gardenia water insertion method --
When choosing water insertion for gardenias, be sure to prepare a water bottle, cutting branches, water, and potassium permanganate disinfectant. The best time for gardenia water insertion is in April, as the environment is very suitable for plant growth, allowing for quick rooting and germination.
First, prepare a healthy branch about 1 inch long and let it dry, leaving 2-3 leaves. Be sure to disinfect the cut end with potassium permanganate solution to prevent wound infection.
After the gardenia branch is prepared, pour some water into the bottle, making sure the water is clean and hygienic. Insert the branch into a wide-mouthed container, with the leaves sticking out of the bottle. After a month or two, when 2 or 3 white roots have grown, the gardenia branch has survived.
2. -- Gardenia soil insertion method --
How to propagate gardenia cuttings: Two methods summarized by an old farmer - water insertion and soil insertion.
Gardenia soil insertion can be done between April and October. It is similar to water insertion, involving the selection of healthy two-year-old branches about 10 inches long. Remove the lower leaves and cut the bottom end at a 45-degree angle. Disinfect the wound as well.
Then, insert the prepared branches into the soil with a spacing of 20-25 cm apart and 7-8 cm between plants. Insert the slanted end of the cutting 2/3 into the soil, press down and water, and set up a low荫棚 for shade. After about half a month, the cuttings will root, and then the young plants can be transplanted into flower pots.
For potting soil, you can use sticky pond mud or garden soil. For example, dry the pond mud, crush it, sieve out the powder, and then add half cottonseed hulls or peat. You can also add some base fertilizer, such as decomposed human manure or soybean cake fertilizer water.
The above is the small experience of how to propagate gardenia cuttings using the two methods summarized by an old farmer - water insertion and soil insertion. Hope it can be helpful to you in your life!