How to divide Clivia miniata: A step-by-step illustration of dividing Clivia miniata plants.

How to propagate Clivia miniata: A step-by-step illustrationHow to propagate Clivia miniata, the details of which are explained by the editor, are here for you to explore! Let's take a look!Clivia miniata, when grown for a long time, will produce side shoots. As these side shoots grow, a single plant may become multiple plants. Some hobbyists want to see an illustration of how to propagate Clivia miniata. In fact, this is not difficult. As long as the root system remains, Clivia miniata can root again, so there is no need to worry too much.Clivia miniata potting process1. PreparationsDo not water the Clivia miniata a few days before propagation, first control the water intake to facilitate the separation of old soil. Then, prepare a sharp knife, such as a utility knife, and some potassium permanganate or carbendazim for disinfection if available.2. Plant removal from potFirst, gently tap the edges and bottom of the pot with your hands, then use a bamboo strip to gently slide along the inner wall of the pot to separate the pot from the soil. Next, use a small trowel to remove some of the surface soil from the pot, then tilt the pot, hold the plant gently with one hand, and grip the pot's drainage hole with the other hand, gently pulling back to easily remove the Clivia miniata from the pot.3. Root soil cleaningAfter removing the Clivia miniata from the pot, first clean the soil from the roots, gently crumble the soil with your hands, then gently tap the roots to remove most of the soil, and finally wash it clean with water.Clivia miniata potting and propagation method steps4. Root separationAfter the roots are cleaned, smooth out the roots. Since there are three plants in the root system, each plant's roots should be smoothed out a bit. Then prepare a utility knife and disinfect it. Cut the connected roots directly and remove any dead or hollow roots from each plant.Clivia miniata potting and propagation method steps5. Soak and disinfect, then dryAfter the roots are trimmed, prepare a large bucket, fill it halfway with water, add potassium permanganate solution, and stir well. Then place the Clivia miniata in the solution to soak for about 10 minutes. Soaking the roots mainly serves to disinfect and sterilize them, which is beneficial for survival after planting.After soaking, take the plant out to dry the roots in a shaded area. Once the moisture has dried, which takes about an hour, you can plant it.6. Potting soil preparationPrepare a new pot and soil in advance. Use a breathable terracotta pot and a mixture of leaf mold, pine needle soil, grass ash soil, and river sand for the soil, making sure to mix it well. Then you can fill the soil into the pot.7. Separate potting of each plantFirst, place some pebbles at the bottom of the pot for better aeration and drainage, then cover them with soil, about 3-5 centimeters thick. Next, take the Clivia miniata plant and place it in the pot, arranging the roots on the soil.Then, fill the soil evenly around the plant, pressing it down gently while ensuring the plant is upright. Once the soil is filled, press the soil around the pot's edge. Since the Clivia miniata has fewer roots, it can be planted a bit deeper. This completes the potting of one plant, and the others can be done similarly.8. Post-potting careAfter potting the Clivia miniata plants, water them once with a settling water. Then, do not water too frequently, as the roots have been pruned and need time to recover. If watered too often, it can lead to root rot.Place the newly potted Clivia miniata in a shaded area to recover. After about a week, you can gradually move them to a bright area with diffused light.The detailed introduction of how to propagate Clivia miniata shared above is hoped to bring some knowledge of flowers to flower enthusiasts.