Which flowers are suitable for cutting in March
This article explains in detail which flowers are suitable for cutting in March and provides an overview of 5 kinds of flowers that are suitable for propagation in spring, including related introductions to green plants and flowers. Corrections are welcome if there are any mistakes!
After entering March, the spring season, all kinds of flowers truly enter the peak growing period, with new buds starting to sprout on the branches. This is also the best stage for plant vitality, making it a perfect time for cutting propagation. Cuttings can take root faster after being inserted, and the temperature is suitable, not as hot as in summer, so the cuttings are less likely to rot. Especially for those planning to cut woody flowers, it is best to do so in this season.
Bougainvillea
Bougainvillea, although a woody plant, is relatively easy to cut, especially during the spring period when the branches are full of nutrients and活力, and the rooting speed is very fast. Some cuttings can even start to bloom after taking root.
Cutting Method
For cutting bougainvillea, it is best to choose slightly thicker branches for insertion. Both thick and thin branches are easy to root, and using thicker branches for insertion can help the plant grow faster and more vigorously, resulting in a higher bloom yield.
The branches can be cut into lengths of 10-15 cm, with the bottom cut at a 45-degree angle, slightly dried before insertion. It is not very demanding on the cutting medium, and even ordinary garden soil can have a high survival rate. After insertion, keep the medium moist and place it in a warm, well-ventilated environment for care.
Rose
Many flower enthusiasts say that roses are not easy to cut, often experiencing black rot in the cuttings. Especially in the summer, the bottom of the cuttings can rot before they have time to root. For this situation, cutting in the spring can be chosen, as the temperature is not so high and can still meet the rooting conditions, resulting in a higher survival rate.
Cutting Method
If you are not very confident in cutting roses, you can prepare some vermiculite in advance as the cutting medium, which has better water retention and breathability and is more conducive to root development. It is also important to choose strong-growing branches, remove the top tender shoots, and use the middle section, cutting about 10 cm for insertion.
Before cutting, you can also soak the cuttings in rooting hormone for about 20 minutes, which can help the cuttings root faster and the roots grow stronger.
Which flowers are suitable for cutting in March
Hydrangea
Hydrangea is an easy flower to cut, usually done after the plant has finished flowering, using the pruned branches for propagation. However, some enthusiasts often fail to cut, so they can choose to cut in the spring. Cut a few dense branches from the mother plant for cutting without affecting normal flowering.
Cutting Method
Hydrangea grows quickly, and the cuttings do not need to be too long, usually 8-10 cm is fine, leaving two leaves at the top and cutting off 1/3 of the entire leaf. This allows for photosynthesis, and the bottom should also be cut at an angle.
If cutting with ordinary potting soil always fails, you can choose to use clean river sand, as it retains water and has good permeability, which is beneficial for plant rooting. After cutting, place it in a shaded, well-ventilated area and spray it with water mist every 2-3 days to keep the medium slightly moist, and it can grow new roots in about twenty days.
Osmanthus
Osmanthus flowers have a strong fragrance and have always been loved by flower enthusiasts. However, few enthusiasts cut osmanthus, thinking that this flower is more difficult to root. Osmanthus cuttings do indeed root slowly, and often rot before they have a chance to root. However, osmanthus is not as difficult to cut as everyone imagines.