What to do when the lucky tree becomes soft when pressed
Today, I will introduce to you how to deal with the lucky tree becoming soft when pressed and the knowledge about using carbendazim to save plants. Here is the detailed introduction.
1. Soil removal and pruning: When the trunk of the lucky tree becomes soft and water comes out when pressed, it indicates internal rot. Remove it from the soil as soon as possible, prune the rotten part, and disinfect and dry it in the sun.
2. Prepare potting soil: Prepare new potting soil, ensuring it is loose, breathable, and has good drainage.
3. Cutting insertion: Dip the bottom of the branches in rooting powder, then insert them into the soil, compact the soil, water thoroughly, and provide a warm, well-ventilated environment.
4. Precautions: Control the frequency of watering, avoid waterlogging, and fertilize with a thin and frequent application method.
I. Soil removal and pruning
When the trunk of the lucky tree becomes soft and water comes out when pressed, it indicates internal rot and must be treated as soon as possible, or the entire tree will die. Remove it from the potting soil, cut off all the soft parts, and also prune yellow and dry branches, leaving only the healthy parts. After pruning, disinfect the area, apply carbendazim to the wound, or soak it in a carbendazim solution for disinfection. Soak for five minutes, then remove to avoid leaving bacteria. After disinfection, place it in a dry, well-ventilated, and shaded environment to dry properly before replanting.
II. Prepare potting soil
The lucky tree has specific soil requirements. Once the trunk rots, the original potting soil cannot be used and needs to be replaced with new soil. The soil must be loose, breathable, have good drainage, and preferably some fertility. You can mix decomposed leaf soil, river sand, and vermiculite or purchase special soil. The prepared soil needs to be disinfected with carbendazim before use.
III. Cutting insertion
After the wound of the lucky tree dries and the new potting soil is prepared, you can insert the cuttings into the soil. Proper management can lead to the growth of new roots. When inserting, first apply rooting powder to the bottom of the branches, then insert them directly into the loose soil, compact the surrounding soil, and water to keep it moist. The soil should be thoroughly wet but not waterlogged, ensuring sufficient water absorption. Provide a warm, well-ventilated environment later, and manage normally after it starts to sprout.
IV. Precautions
The softening and rotting of the lucky tree's trunk are often caused by excessive watering during cultivation. The lucky tree is afraid of waterlogging and has poor drought resistance, making it very sensitive to water. Watering must control the amount and frequency. Water promptly when the soil is dry, and water thoroughly each time, avoiding waterlogging. Also, pay attention to the fertilization method, using a thin and frequent application to avoid root burning and rot. Strengthening care can prevent further rotting.
The above shares the complete content on what to do when the lucky tree becomes soft when pressed and how to save it using carbendazim. Green plant enthusiasts might find it useful to refer to this information.