How to propagate roses through cutting
Article abstract: This article shares some small experiences in plant cultivation regarding how to propagate roses through cutting and the timing and methods of rose cutting, as follows:
Rose cutting is usually done in spring and autumn, specifically in April-May or September-October. The climate during these periods is mild and suitable, which increases the viability and ensures a higher survival rate.
One, Timing for Rose Cutting
Rose cutting is typically done in spring and autumn, specifically in April-May or September-October. The climate during these periods is mild and suitable, making it easier for cuttings to survive and ensuring a higher survival rate. Moreover, it does not cause significant harm to the rose plant and does not result in any adverse effects.
Two, Methods of Rose Cutting
1. Selecting Branches
Select vigorous, lignified branches from the rose plant, cut them from the mother plant, and retain a length of about 10-15 centimeters. Remove all leaves from the bottom, retain 3-4 buds, and cut the lower end of the branch at an oblique angle to facilitate contact with the soil and accelerate root growth.
2. Preparing Potting Soil
Rose cutting uses well-draining, loose, and fertile acidic soil. It is best to mix humus soil and garden soil in a 1:1 ratio. A small amount of river sand can be added to improve drainage. There is no need to use a substrate fertilizer at the bottom of the potting soil to avoid adverse effects on the plant.
3. Performing the Cutting
Use chopsticks to make a hole about 5 centimeters deep in the prepared soil. Insert the processed branch into the hole and use a wooden stick as support next to it. Tie the branch and the wooden stick together, compact the surrounding soil, seal with plastic film, water it, and place it in a well-ventilated area for cultivation.
Three, Care Methods
1. Temperature
After cutting, roses thrive in an environment with a temperature of 23-27 degrees Celsius. It should not be too high or too low to avoid affecting the normal growth of the roots.
2. Watering
Water the cut roses based on the moisture level of the soil. When the soil is too dry, water it promptly. Do not overwater to avoid waterlogging issues.
The above is a specific introduction to how to propagate roses through cutting and the timing and methods of rose cutting, for reference by netizens.