How to propagate the Fragrant Wisteria through cutting
This article provides a guide on how to propagate the Fragrant Wisteria through cutting and shares some small experiences on the care of green plants for this method, as detailed below:
1. Selecting cuttings: Choose semi-lignified branches that have bloomed in the current year as they have a stronger germination ability.
2. Handling cuttings: Cut the cuttings into short sections, each with at least two pairs of leaves, and cut the leaves in half. Soak the cuttings in a rooting solution for a while to promote root growth.
3. Preparing the substrate: The substrate for cutting should be loose, breathable, and have good drainage.
4. Planting the cuttings: Make a small hole first, then insert the cutting and water thoroughly. Provide a shaded, ventilated, and humid environment later on.
One, Selecting cuttings
When propagating the Fragrant Wisteria through cutting, choose semi-lignified branches that have bloomed in the current year as they have a higher survival rate. It's best not to choose branches that have recently bloomed as they are not fully mature, with too little lignification, which can cause the cuttings to wilt easily and have difficulty rooting.
Two, Handling cuttings
After cutting, the cuttings need to be cut into sections, each with at least two pairs of leaves, and the leaves should be cut by half to two-thirds to reduce the consumption of nutrients and moisture. It's best to soak the cuttings in a rooting solution for 10-15 minutes to promote root growth. As the branches of the Fragrant Wisteria are too thin and weak, after handling, there's no need to dry them in the sun, and they should be inserted into the soil as soon as possible to avoid excessive evaporation of water.
Three, Preparing the substrate
The substrate used for cutting should ideally be loose, breathable, and have good drainage. A mixture of coarse sand, perlite, vermiculite, and peat soil can be used to prepare the substrate, which should meet the basic requirements. Note that the substrate must be disinfected before use to avoid any residual eggs or pathogens.
Four, Planting the cuttings
After the substrate is prepared and the cuttings are handled, proceed with the cutting. First, make a few small holes in the surface of the substrate with chopsticks, then insert the cut sections into the holes, press the surrounding soil firmly, and water thoroughly. Later on, provide a shaded and well-ventilated environment and cover with a plastic bag, ventilating one to two times a day. If the substrate dries out, water it in time to keep the soil slightly moist. Under suitable conditions, it will take about 15-20 days to root and survive. Do not rush to transplant after rooting; wait until the roots are 5 centimeters long and new buds have emerged before transplanting, as this will help the plant adapt to the new environment more quickly.
The above is the specific content on how to propagate the Fragrant Wisteria through cutting and related methods, and copying is prohibited without permission!