When to plant plum blossom seeds
An article about when to plant plum blossom seeds and the timing and methods of planting plum, the following will introduce you to understand.
Plum has various ways of propagation. Today, the editor will tell you about the process of each propagation method of plum.
① Sowing: In July and August every year, after picking the mature fruit, you can take out the seeds from the fruit receptacle. When sowing, mix the seeds with the new high-fat film before spreading them, which can improve the survival rate of the seeds. After more than ten days, the seeds can sprout seedlings. If well maintained, they can grow into seedlings 20 centimeters high in the same year.
② Cutting: You can cut a strong branch without diseases and insect pests, insert it into the sandy soil, water it thoroughly, and then spray the new high-fat film on the branch. This can ensure that the branch is ventilated and protected from diseases and insect pests, putting on a perfect health suit for the branch, allowing the cutting to quickly adapt to the new growth environment. After 15 to 20 days, new seedlings can grow, and after the roots grow, they can be transplanted into pots. After three to four years of cultivation, they can bloom.
③ Division: In March and April, when the leaf buds just begin to germinate, you can carry out the division propagation. The mother plant should be 20 to 30 centimeters high from the ground, and it is best to have topped it last year, so that the mother plant can accumulate more nutrients and make the branches grow stronger. When dividing, first dig out the soil around the mother plant, then use a disinfected blade to quickly cut off a part of the plant, disinfect and sterilize the wound, and then plant it into another pot.
When to plant plum blossom seeds
④ Grafting: Here, a cut grafting method is used. Choose a scion 6 to 7 centimeters long, with at least one or two pairs of strong buds, then pare both sides of the scion until the xylem can be faintly seen, with a斜面 about 3 to 4 centimeters long.
Trim all the ground above the rootstock 3 to 6 centimeters away from the ground, and make a downward cut one-third of the diameter of the rootstock, then split the top of the rootstock 4 to 5 centimeters deep, and gently insert the scion into the cut of the rootstock.
After grafting, apply about 2 grams of wet mud prepared in advance to the joint, then cover the soil to the top of the scion to maintain a moist environment. Also, spray the new high-fat film over the entire plant surface to protect the normal growth of the plant, prevent infection by diseases and pests, improve the plant's resistance, and provide sufficient nutrients for rapid growth. After grafting, the plant can continuously grow and develop through photosynthesis, fully integrate the upper and lower parts as one, and grow stronger branches.
The introduction of when to plant plum blossom seeds and the timing and methods of planting plum introduced above (Green Plant Enthusiast Network) is for everyone to learn and understand!