What kind of soil is suitable for planting jasmine
A comprehensive introduction to the soil suitable for planting jasmine in the aspect of green plants and flowers, the following is introduced by the editor of this site.
What kind of soil is suitable for planting jasmine
Jasmine prefers slightly acidic soil, requiring the growing soil to be rich in organic matter and have good water permeability and ventilation. It can use 4 parts of field soil, 4 parts of compost, 2 parts of river sand or rice husk ash, plus an adequate amount of thoroughly decomposed dry cake residue, chicken and duck manure, etc., and sieve out the powder and coarse particles, using coarse particles as the base and mulch. When transplanting jasmine, ordinary loose soil can be used, but it needs to be disinfected.
Jasmine soil
Jasmine prefers slightly acidic soil, which means a pH value of 6 to 6.5 is the most suitable for its growth. When planting, the growing soil should be rich in organic matter and have good water permeability and ventilation. Potted jasmine should be repotted and replaced with soil once a year. During repotting, remove the old soil and residual roots and replace them with new growing soil to improve the soil granular structure and nutrient content.
Jasmine can be grown in ordinary soil, which is mostly neutral. Jasmine can survive in this kind of soil, and it can also be cultivated in nutrient-rich soil, which can make the jasmine grow faster and better.
Jasmine soil mixing method
1. Nutrient-rich soil
The soil for jasmine should be loose, fertile, with good drainage and slightly acidic, with a pH value between 5.5-7.
2. Mixing
When mixing soil, you can use 4 parts compost and garden soil, then mix in 2 parts fine sand to improve drainage, or use 1 part each of garden soil, decayed leaf soil, and sawdust, and then add a small amount of cake residue as a base fertilizer.
Jasmine potting soil replacement
1. Preparation: Before repotting, water thoroughly and wait for 1 to 2 days until the potting soil is neither dry nor wet, then it can be repotted.
2. Pot removal: First, tap the outer wall of the pot to separate the pot and the soil. If tapping the outer wall does not work, insert a knife along the inner wall of the pot to separate it.
3. Separation: Gently remove the soil from the separated jasmine, trying not to damage the roots. Then inspect the separated roots for any old, diseased, or dead roots and cut them off.
4. Filling soil: Put the prepared soil in the pot, first filling one-third, then holding the jasmine with one hand and filling the soil with the other, pressing it down to make sure the roots and soil are in full contact without any gaps. Do not fill the pot completely, leaving a 2 cm height for watering later.
5. Watering: This time, make sure to water thoroughly, focusing on the "thorough" aspect. It is good if a lot of water flows out from the bottom of the pot.
The above is a specific introduction to the soil suitable for planting jasmine, for netizens to refer to.