How to cut the branches for Epipremnum aureum cutting
About the content of cutting branches for Epipremnum aureum cutting and the step-by-step illustration of hydroponic Epipremnum aureum cutting in the field of green plants and flowers, the following editor will introduce to everyone.
Key point: The main method of propagation for Epipremnum aureum is cutting. Simply cut a section of the Epipremnum aureum branch and plant it, usually about 3 nodes. Of course, there are hydroponic and soil-based methods for Epipremnum aureum cutting propagation. Relatively speaking, hydroponic rooting is simpler. As long as the temperature is sufficient and the water temperature is the same as the ambient temperature, it can basically take root. Of course, it can also be soil-based. Epipremnum aureum takes longer to root in soil but has stronger roots. For a large number of cuttings, soil-based propagation is used.
For the question asked by netizens, the leaves of the Epipremnum aureum cutting have not straightened up after seven days. Should they continue to wait or switch to hydroponics? In fact, cutting Epipremnum aureum is not that difficult. After the netizens' cutting, the leaves have not straightened up. I think the main reason is insufficient humidity. Generally, after cutting, the leaves can start to look lively within a few days.
The netizens did not provide pictures, so it is impossible to analyze specifically. Since the netizens have already cut for seven days, there is no need to make further changes. Just continue to care for it. There is no need to pull it out and replant it, as this is not conducive to the rooting of the Epipremnum aureum branches. Because after switching to hydroponics, it needs to adapt to the water environment, which has already consumed some nutrients. Continuing to consume more will likely make it difficult to root.
You don't need to buy Epipremnum aureum, just pick a branch, pay attention to 3 key points of cutting, and one cutting can be used for dozens of pots.
1. Method for cutting Epipremnum aureum branches
It is recommended to control the length of the Epipremnum aureum branches to be cut to about 2 to 3 nodes. Of course, there are aerial roots on the branches of Epipremnum aureum. When cutting the branches, try to keep the roots if possible, as this makes it easier to adapt quickly after planting.
How to cut branches for Epipremnum aureum cutting
2. Cutting method
For Epipremnum aureum cutting, if you want to germinate and root quickly, I suggest using plain soil for cutting. I recommend using plain sand for cutting, as it is easy to root and the large temperature difference is conducive to stimulating germination and rooting.
3. Moisture retention and rooting
The later care is very important. If the temperature is low, you can cover it with a film to keep it warm and moist. Now that the temperature is sufficient, just cut and water thoroughly for care. Normally keep the potting soil slightly moist, and it will germinate in half a month and root in about a month.
What I want to say in the end is that cutting Epipremnum aureum is very simple and there is no need to make it too complicated. I suggest using plain soil for cutting, as it is conducive to rooting. Using nutrient-rich soil for cutting can easily cause seedlings to die, which is also an important experience. Also, when cutting, make sure to maintain the moisture of the branches.
The above (Green Plant Enthusiast Network) introduces the complete content of how to cut branches for Epipremnum aureum cutting and its hydroponic cutting step-by-step illustration for your comprehensive understanding and reference!