Propagation Methods and Precautions for Glass Begonia Cuttings
A detailed introduction to the propagation methods and precautions for glass begonia cuttings for concerned netizens, followed by a sharing of the specific content.
Propagation Methods and Precautions for Glass Begonia Cuttings
It is suitable to propagate glass begonias from March to May in spring and from August to September in autumn. Cut a vigorous, healthy branch from the plant, free from diseases and pests, without flower buds, about 10 cm in length. Make a small hole in the prepared soil with a chopstick, then gently insert the branch into it, with the depth being about one-third of the cutting length, and water thoroughly.
When glass begonias bloom, they are colorful and have various colors such as white, pink, rose red, and purple red. They can bloom continuously all year round with a suitable growing temperature and are very popular among flower enthusiasts. There are three methods of propagation for glass begonias: cuttings, division, and seeding.
Timing for Propagation of Glass Begonia Cuttings
When propagating glass begonias, attention should be paid to timing. It can be done from March to May in spring, or from August to September in autumn, which also has a good effect and a relatively faster rooting speed. It is also possible to propagate in other seasons, but the survival rate is much lower than in spring and autumn.
Tips for Propagating Begonia Cuttings
1. Cutting the Branches
From the glass begonia, cut a vigorous, healthy branch, free from diseases and pests, without flower buds, about 10 cm in length. After cutting, remove the leaves at the bottom to prevent rotting after propagation, then place it in a shaded area and slightly dry the cut end.
2. Preparing the Soil
After preparing the branches, the soil can be prepared. Fine sand soil can be used, and to ensure nutrition, a mixture of sand and garden soil can also be used. This soil is not only loose but also rich in nutrients.
3. Propagating the Cuttings
Make a small hole in the prepared soil with a chopstick, then gently insert the branch into it, with the depth being about one-third of the cutting length, and do not propagate too densely.
Precautions for Propagating Glass Begonia Cuttings
After the propagation of glass begonia cuttings is completed, pay attention to the following maintenance management, water the soil thoroughly, place it in a cool and well-ventilated area, control the temperature between 20-30 degrees Celsius, and it can root in about 2-3 weeks, after which it can be maintained normally.
Have you understood the detailed introduction to the propagation methods and precautions for glass begonia cuttings shared above?